Operation and Features 2
E364xA User’s and Service Guide 69
4 Save the operating state.
Recalling a stored state
1Turn on the recall mode.
Memory location 1 will be displayed in the recall mode.
2 Select the stored operating state.
You can select the above RESET mode to reset the power supply to the power-
on state without turning power off/on or without using the *RST command
over the remote interface. Refer to “*RST” on page 122 for more details on the
*RST command.
3 Recall the stored operating state.
DONE
Before proceeding with the steps listed below, ensure that the outputs are
disabled throughout the recall procedure (the CV or CC annunciator turns off
and the OFF annunciator turns on).
1: P15V_TEST
2:STATE2
RESET
DONE
To Next Page
Loading...
Need help?
General
