Remote Operations 6
Keysight J7201A/B/C Operating and Service Manual 51
USB configuration
The USB interface requires no front panel or remote configuration. The USB is fixed and can not be
changed - it is set at the factory and is unique for each J7201A/B/C.
LAN configuration
The J7201A/B/C has three LAN operating modes:
– Dynamic mode (Dynamic Host Configuration Protocol or DHCP)
– Auto IP mode (Local PC Control or isolated LAN)
– Static mode (Manual mode)
Refer to “Connecting over LAN” on page 84 to configure the above LAN operating modes.
For further information on USB configuration, refer to “Connecting over USB” on page 83.
Before connecting the USB cable, make sure that I/O software is installed on your computer.
For more information about Keysight I/O Libraries Suite software, refer to Connectivity Guide. If
you have installed other I/O software refer to documentation that accompanies the software.
To Next Page
Loading...
