Keysight Technologies J7201A - Page 70

6 Remote Operations
70 Keysight J7201A/B/C Operating and Service Manual
Examples
To set the model string to “J7201C”:
SYST:PERS:MOD “J7201C”
To query the set model string:
SYSTem:PERSona:MODel?
Related Commands
SYSTem:PERSona:MODel:DEFault
SYSTem:PERSona:MODel:DEFault
Sets the model string to default (depends on the model).
SYSTem:PERSona:MODel:DEFault
Examples
To set the model string to default:
SYST:PERS:MOD:DEF
To query the default model string:
SYSTem:PERSona:MODel:DEFault?
Related Commands
SYSTem:PERSona:MODel
SYSTem:SET
Sets up the instrument as defined by the data in the binary block of data from the
computer.
- A binary block of data, consisting of bytes of setup information. The number of bytes is
a dynamic number that is read and allocated by the instrument’s firmware.
- SYSTem:SET query operates the same as the *LRN? query
SYSTem:SET <Binary Block>
Maximum n/a
Units None
Query? Yes
Set? Yes
Set/Return Parameters String
Minimum n/a
Maximum n/a
Units None