Remote Operations 5
Keysight J7211A/B/C Operating and Service Manual 45
Figure 5-1 Example of control using telnet
5 Press ] while holding down Ctrl in the telnet screen to break the connection to the J7211A/B/C.
The telnet prompt appears. Type “quit” at the telnet prompt and press Enter to finish using
telnet.
Control from a program (using port 5025)
When controlling the J7211A/B/C from a program on the external controller, use the socket of port
5025 for connection. Figure 5-2 shows an example of controlling via a program.
To Next Page
Loading...
