Keysight M9037A PXIe Embedded Controller User Guide 59
BIOS Setup Controller Maintenance
Electrostatic Discharge (ESD)
Electrostatic discharge (ESD) can damage or destroy electronic components. All
work on electronic assemblies should be performed at a static-safe work station.
The following figure shows an example of a static-safe work station using two
types of ESD protection. Purchase acceptable ESD accessories from your local
supplier.
- Conductive table-mat and
wrist-strap combination.
- Conductive floor-mat and
heel-strap combination.
Both types, when used together,
provide a significant level of ESD
protection. Of the two, only the
table-mat and wrist-strap
combination provides adequate
ESD protection when used alone.
To ensure user safety, the
static-safe accessories must
provide at least 1 MΩ of isolation
from ground.
Inspect for damage
After unpacking the embedded controller, carefully inspect it for any shipping
damage. Report any damage to the shipping agent immediately, as such
damage is not covered by the warranty.
To avoid damage when handling a module; do not touch exposed
connector pins.
To Next Page
Loading...
Need help?
General
