M9037A PXIe Embedded Controller
User Guide
9
1 Introduction
Keysight’s M9037A is a Windows PC that fits in slot 1 of a PXIe chassis. It is a 3U,
4-slot PXIe Embedded Controller providing:
- Intel Haswell Core
TM
i7-4700EQ quad-core, 2.4 GHz processor
- 4 GB standard (or optional 8 or 16 GB) 1600 MHz DDR3 Memory
*
- 240 GB SATA 2.5 inch solid state drive (SSD) front panel removable
- Integrated IO on the front panel includes two Gigabit Ethernet ports, four USB
2.0 ports
†
, two USB 3.0 ports, GPIB connector, two DisplayPort video ports
(also known as DisplayPort++), one PCIe x8 connector
- Front Panel SMB Trigger Connector used to route an external trigger signal
(TTL level) to/from the PXI backplane with software trigger
- Preloaded with Keysight IO Libraries and Microsoft Windows operating system
- Pre-installed IVI drivers for the Keysight PXIe chassis
Related Documentation
A Windows OS and all M9037A drivers required to operate the controller and
chassis
were installed at the factory, no additional drivers are required. Complete
M9037A documentation, as well as the PXIe Chassis Family documentation, is
pre-installed on the M9037A SSD. It can be found from the Windows Start menu
under Keysight. Descriptions of the PXIe Chassis Family can be found at:
www.keysight.com/find/pxie-chassis.
Adobe Reader is required to view the documentation supplied on the M9037A
and product CD. It is available free at: www.adobe.com. You should install this on
your M9037A prior to attempting to open a.PDF file.
For the latest M9037A specifications, go to:www.keysight.com/find/M9037A.
For the IVI driver, help file, program examples, etc. go to:
C:\Program Files\IVI Foundation\IVI\Drivers\AgPxiPc
or
C:\Program Files (x86)\IVI Foundation\IVI\Drivers\AgPxiPc
* The M9037A has two 240-pin, RDIMM sockets that support DDR3-1600 REG/ECC RAM sticks. The standard
M9037A configuration is a single 4 GB memory module with a factory option to provide either 8 or 16 GB
memory. A 32-bit OS system may not be able to address above 4GB memory space. To use the full 16GB
memory, a 64-bit OS must be used.
† The USB 2.0 and 3.0 ports do not support the USB Battery Charging specification. Do not connect
non-standard or defective USB devices.
To Next Page
Loading...
Need help?
General
