442 Keysight CXG, EXG, and MXG X-Series Signal Generators Service Guide
Performance Verification and Adjustment Software
Test Software Overview
Test Software Overview
The X-Series Signal Generators can be fully tested and adjusted with the use
of the N7822A Calibration Application software.
To download a copy of the Performance Verification & Adjustment software as
well as find information on software licensing, visit the Keysight Calibration &
Adjustment Software web site at:
http://www.keysight.com/find/calibrationsoftware
Performance Verification Tests
Performance verification tests are tests designed to provide the highest level of
confidence that the instrument being tested conforms to published,
factory-set specifications. The tests are supplied in an automated test software
package. Performance tests are designed to test an instrument operating
within the operational temperature range defined by the instrument
specifications.
A complete list of the performance verification tests can be found at:
http://cal.software.keysight.com/MXG/Help/MXGWebHelp.htm
Prior to running any performance verification tests be sure that there are no
instrument error messages and that all Self Tests pass.
Adjustments
Adjustments are procedures designed to reset various circuit parameters or
calculate correction values. The adjustments are supplied in an automated test
software package. The software is designed to adjust an instrument operating
within the operational temperature range defined by the instrument
specifications.
Never perform adjustments as routine maintenance. Adjustments should be
performed only after a repair or a performance test failure. A list of adjustments
that need to be ran after an assembly is replaced can be found in Chapter 16,
“Pre and Post-Repair Procedures”
A complete list of the adjustments can be found at:
http://cal.software.keysight.com/MXG/Help/MXGWebHelp.htm
To Next Page
Loading...
Need help?
General
