Compatibility Commands
This section describes the compatibility of the Keysight RPS7900-series with existing Keysight N7900-
series Advanced Power Systems (APS). Because of their feature sets, only programs written for the
N7900 Advanced Power Systems are compatible with the Regenerative Power System (RPS) models.
Note that not all features are common to both families.
APS code-compatible commands with RPS models
These Keysight N7900 APS commands are compatible with the RPS models.
N7900-series APS commands Action or equivalence on RPS models
[SOURce]
:RESistance<value>
:STATe <Bool>
[SOURce]
:VOLTage
:RESistance <value>
:STATe <Bool>
APS feature set comparison with RPS models
The following table compares the feature set of the Keysight N7900 APS models with the feature set
of the RPS models
Feature In N7900 APS models?
Two quadrant operation
Voltage and current priority operation
Voltage and current slew rates
Resistance programming (in voltage priority mode)
Output bandwidth selection (in voltage priority mode)
Yes
Yes
Yes
Yes
Yes
Output triggering
Single step output change
Output list of up to 512 points
Constant-dwell arbitrary waveform – up to 64k points
Yes
Yes
Yes
Scalar measurements
DC, RMS, High/Low, Min/Max current scalar measurements
DC, RMS, High/Low, Min/Max voltage scalar measurements
Average Power
Amp hours and Watt hours
Yes
Yes
Yes
Yes
Digitized measurements
Simultaneous voltage and current measurements
Current, voltage, and power array data
External data logging
Yes
Yes
Yes
5 SCPI Programming Reference
260 Keysight RP7900 Series Operating and Service Guide
To Next Page
Loading...
Need help?
General
