[:IMMediate]
[:AMPLitude] <value> Sets the output resistance level.
:STATe 0|OFF|1|ON Enables or disables output resistance programming.
:SLEW
[:IMMediate] <value>|INFinity Sets the voltage slew rate.
:MAXimum 0|OFF|1|ON Enables or disables the maximum slew rate override.
STATus
:OPERation
[:EVENt]? Queries the operation event register.
:CONDition? Queries the operation condition register.
:ENABle <value> Sets the operation enable register.
:NTRansiton <value> Sets the Negative transition filter
:PTRansiton <value> Sets the Positive transition filter
:PRESet Presets all Enable, PTR, and NTR registers.
:QUEStionable<1|2>
[:EVENt]? Queries the questionable event register.
:CONDition? Queries the questionable condition register.
:ENABle <value> Sets the questionable enable register.
:NTRansiton <value> Sets the Negative transition filter
:PTRansiton <value> Sets the Positive transition filter
SYSTem
:COMMunicate
:LAN|TCPip:CONTrol? Returns the initial socket control connection port number.
:RLSTate LOCal|REMote|RWLock Configures the remote/local state of the instrument.
:DATE <yyyy>, <mm>, <dd> Sets the date of the system clock.
:ERRor? Reads and clears one error from the error queue.
:LFRequency? Returns the power-line reference frequency.
:LFRequency
:MODE AUTO|MAN50|MAN60 Specifies automatic or manual line frequency detection.
:PASSword
:FPANel
:RESet Resets the front panel lockout password to zero.
:REBoot Reboots the instrument to its power-on state.
:SDS (SDS commands apply to N795xA, N796xA only)
:CONNect Connect to the SDS unit.
:MODE AUTO|MANual Selects the connection mode at power-on.
:DIGital
:DATA
:INPut? Reads the SDS digital port signals.
:OUTPut <value> Sets the SDS digital output signals.
:ENABle 0|OFF|1|ON Enables or disables the SDS unit.
:STATus? Returns the SDS status.
Keysight RP7900 Series Operating and Service Guide 31
1 Quick Reference
To Next Page
Loading...
