:TERMinate
:LAST 0|OFF|1|ON Determines the output value when the list terminates.
:TOUTput
:BOSTep
[:DATA] <Bool>{,<Bool>} Generates a trigger out at the Beginning Of STep
:POINts? Returns the number of list points.
:EOSTep
[:DATA] <Bool>{,<Bool>} Generates a trigger out at the End Of STep
:POINts? Returns the number of list points.
:VOLTage
[:LEVel] <value>{,<value>} Specifies the setting for each list step.
:POINts? Returns the number of list points.
[SOURce:]
POWer
:LIMit? Returns the output power limit of the instrument
[SOURce:]
STEP
:TOUTput0|OFF|1|ON Specifies whether a trigger out is generated when a transient step occurs.
[SOURce:]
VOLTage
[:LEVel]
[:IMMediate]
[:AMPLitude] <value> Sets the output voltage when in voltage priority mode.
:TRIGgered
[:AMPLitude] <value> Sets the triggered output voltage.
:BWIDth LOW|HIGH1 Sets the voltage compensation (RP795xA, RP796xA)
:RANGe 0 | 1 | 2 Sets the voltage compensation. (RP793xA, RP794xA)
:LEVel 0 | 1 | 2, <value> Sets the compensation frequency. (RP793xA, RP794xA)
:LIMit
[:POSitive]
[:IMMediate]
[:AMPLitude] <value> Sets the voltage limit when in current priority mode.
:LOW <value> Sets the low-voltage limit. (RP793xA, RP794xA)
:MODE FIXed|STEP|LIST|ARB Sets the transient mode.
:PROTection
[:LEVel] <value> Sets the over-voltage protection level.
:LOW
[:LEVel] <value> Sets the low-voltage protection level. (RP793xA, RP794xA)
:DELay <value> Sets the low-voltage protection delay. (RP793xA, RP794xA)
:STATe 0|OFF|1|ON Enables or disables low-voltage protection. (RP793xA, RP794xA)
:RESistance
[:LEVel]
1 Quick Reference
30 Keysight RP7900 Series Operating and Service Guide
To Next Page
Loading...
