Stacking Instruments 63
Rack Mounting 64
Single Unit Connections 66
Power Cable Connections 66
Output Connections 68
Single Load Connections 70
Multiple Load Connections 71
Remote Sense Connections 72
Additional Load Considerations - all Models 74
Additional Load Considerations - RP793xA, RP794xA 75
Multiple Unit Connections 78
Parallel Connections 78
Load and Sense Connections 78
Master/Slave Connections - for all models 80
Current Sharing Connections - RP795xA, RP796xA 81
Series Connections 82
Interface Connections 83
GPIB Connections 83
USB Connections 83
LAN Connections - site and private 84
Digital Port Connections 85
Interface Cover Installation 86
3 Getting Started 87
Using the Front Panel 88
Turn the Unit On 88
Set the Output Voltage 89
Set the Output Current 90
Set Over-voltage Protection 91
Enable the Output 92
Use Built-in Help System 92
Remote Interface Configuration 93
Introduction 93
USB Configuration 93
GPIB Configuration 93
LAN Configuration 94
Modifying the LAN Settings 95
Using the Web Interface 98
Using Telnet 99
Using Sockets 99
Interface Lockout 99
4 Using the Regenerative Power System 101
Programming the Output 102
Set the Output Priority Mode 102
Set the Output Voltage 103
Set the Output Current 103
Set the Slew Rate 104
Set the Output Resistance 104
Keysight RP7900 Series Operating and Service Guide 4
To Next Page
Loading...
Need help?
General
