Getting Started 1
Keysight 2050/60 X-Series User’s Guide 23
Connect the L2051XA/52XA/53XA/61XA/62XA/63XA sensor
Connect the L2051XA/52XA/53XA/61XA/62XA/63XA via any of the following LAN
operating modes:
– Dynamic IP (Dynamic Host Configuration Protocol or DHCP)
– Auto IP (Local PC control or isolated (non-site) LAN)
– Static IP (Manual mode)
The default LAN operating mode of the L2051XA/52XA/53XA/61XA/62XA/63XA is
Dynamic IP.
Dynamic IP and Auto IP are enabled on the L2051XA/52XA/53XA/61XA/62XA/63XA
shipped from Keysight. This allows the L2051XA/52XA/53XA/61XA/62XA/63XA to
automatically obtain an address on the network.
The L2051XA/52XA/53XA/61XA/62XA/63XA communicates with the DHCP server to
obtain the LAN interface configuration. If the DHCP server is not detected, then either the
DHCP server is not present or it does not allow the L2051XA/52XA/53XA/61XA/62XA/
63XA to obtain an IP address. The L2051XA/52XA/53XA/61XA/62XA/63XA will then try to
obtain the LAN configuration using AutoIP if enabled, otherwise the L2051XA/52XA/53XA/
61XA/62XA/63XA will try to use the static IP set in the L2051XA/52XA/53XA/61XA/62XA/
63XA. If required, push the LAN reset switch to reset the L2051XA/52XA/53XA/61XA/
62XA/63XA LAN configuration to a known default state.
Dynamic IP mode
In this mode, the IP address, subnet mask, and default gateway values are obtained from a
DHCP server.
The LED indicator will turn red indicating the following error when the DHCP server is not
detected:
-310, "System error;The sensor could not obtain a LAN configuration using DHCP. The
sensor will try to obtain IP address using AutoIP if enabled”.
For more information on LAN instrument connectivity, refer to the Keysight IO Libraries
Suite Connectivity Guide.
To Next Page
Loading...
Need help?
General
