196 Keysight Signal Generators Programming Guide
Programming the Status Register System
Status Groups
negative (1 to 0).
Data Questionable Power Event Register
The Data Questionable Power Event Register latches transition events from the condition register as
specified by the transition filters. Event registers are destructive read- only. Reading data from an
event register clears the content of that register.
Commands:
STATus:QUEStionable:POWer:NTRansition <value> (negative transition), or
STATus:QUEStionable:POWer:PTRansition <value> (positive transition), where
<value> is the sum of the decimal values of the bits you want to enable.
Queries:
STATus:QUEStionable:POWer:NTRansition? STATus:QUEStionable:POWer:PTRansition?
Query: STATus:QUEStionable:POWer[:EVENt]?
To Next Page
Loading...
