EasyManuals Logo

Keysight E4980A Service Guide

Keysight E4980A
137 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Keysight E4980A/E4980AL Precision LCR Meter 5
Caution
Safety Notice Supplement
Safety Notice Supplement
This equipment complies with EN/IEC61010-1:2001.
This equipment is of MEASUREMENT CATEGORY I (CAT I). Do not use for
CAT II, III, or IV.
Do not connect the measuring terminals to mains.
This equipment is a POLLUTION DEGREE 2, INDOOR USE product.
This equipment is tested in stand-alone condition and in combination with
the accessories supplied by Keysight Technologies against the requirement
of the standards described in the Declaration of Conformity. If it is used as a
system component, compliance of related regulations and safety
requirements are to be confirmed by the builder of the system.

Table of Contents

Other manuals for Keysight E4980A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight E4980A and is the answer not in the manual?

Keysight E4980A Specifications

General IconGeneral
Frequency Range20 Hz to 2 MHz
Basic Accuracy0.05%
DC Bias Voltage0 V to ±40 V
Measurement FunctionsL, C, R, Z, D, Q
DC Bias Current0 A to 20 mA (using external DC bias source)
DisplayLCD
InterfaceLAN, USB, GPIB
Dimensions426 mm (W) x 177 mm (H)
Weight13.5 kg

Related product manuals