Chapter 6: Replacing Assemblies
To replace the Intel motherboard with the ADLINK motherboard
125
11
Remove the AutoProbe board using the instructions beginning on page 104.
12 Using a 9/16" nut driver, remove the hex nuts that secure the BNC connectors
to the front panel. (See See Figure 6- 13 on page 108).
13 Remove the four Torx T15 screws that secure the chassis sides to the front
panel assembly.
Figure 6-30
14
Remove the ten Torx T10 screws that secure the front panel cover plate to the
front casting. The four screws marked āLā on the diagram are longer so be sure
to re- assemble correctly.
Flat-panel display driver multi-colored
cable
T10 Screws (10)
Cal cable
Touch screen
USB connector
Keyboard ribbon
cable
L
L
L
L
To Next Page
Loading...
