Chapter 6: Replacing Assemblies
To replace the Intel motherboard with the ADLINK motherboard
129
28
Re- install the Motherboard assembly into the chassis:
• Install the 3 long Torx T10 screws and two short T10 into the tray holding
the motherboard assembly to the frame chassis.
29 Re- install eight short T20 screws in rear panel attaching deck to the frame
chassis. Torque to 8 in-lb.
30 Re- install three short T10 screws and filler plate to the rear panel. Torque to
5 in- lb.
31 Re- install the Acquisition Interface PCI card into the slot marked GPIB on the
rear panel.
32 Connect new cables:
a Connect new display cable to motherboard.
To Next Page
Loading...
