Keysight N3300A - Page 17

1 - Quick Reference
16
Front Panel Menus - continued
VOLT
Sets the input voltage
V:MODE
Sets the voltage mode (FIXED, LIST)
V:RANG
Sets the input voltage range
V:SLEW
Sets voltage slew rate
V:SLW:N
Sets voltage slew rate for negative transitions
V:SLW:P
Sets voltage slew rate for positive transitions
V:TLEV
Sets the transient input voltage
V:TRIG
Sets the triggered input voltage
TRAN
Enables/disables the transient generator (OFF/ON)
T:DCYC
Sets the transient duty cycle in continuous mode
T:FREQ
Sets the transient frequency in continuous mode
T:MODE
Sets the transient mode (CONT, PULSE, TOGGLE)
T:TWID
Sets the transient pulse width in pulse mode
INIT:IMMED
Initiates the trigger system
ABORT
Aborts the initiated trigger
LST:STEP
Sets the method of incrementing steps (ONCE, AUTO)
LST:CNT
Specifies the number of times the list is cycled
DWEL:0 EOL
Specifies the time period of each step
CURR:0 EOL
Specifies the current setting for each step
C:RANG:0 EOL
Specifies the current range for each step
C:SLEW:0 EOL
Sets the current slew rate for each step
C:SLW:N:0 EOL
Sets the negative current slew rate for each step
C:SLW:P:0 EOL
Sets the positive current slew rate for each step
C:TLEV:0 EOL
Sets the transient input current for each step
FUNC:0 EOL
Sets the list regulation mode (CURR, RES, VOLT)
RES:0 EOL
Specifies the resistance setting for each step
R:RANG:0 EOL
Specifies the resistance range for each step
R:SLEW:0 EOL
Sets the resistance slew rate for each step
R:SLW:N:0 EOL
Sets the negative resistance slew rate for each step
R:SLW:P:0 EOL
Sets the positive resistance slew rate for each step
R:TLEV:0 EOL
Sets the transient input resistance for each step
TRAN:0 EOL
Enables/disables the transient level for each step
T:DCYC:0 EOL
Sets the transient duty cycle for each step
T:FREQ:0 EOL
Sets the transient frequency for each step
T:MODE:0 EOL
Sets the mode of the transient generator (CONT, PULSE)
T:TWID:0 EOL
Sets the transient pulse width for each step
VOLT:0 EOL
Specifies the voltage setting for each step
V:RANG:0 EOL
Specifies the voltage range for each step
V:SLEW:0 EOL
Sets the voltage slew rate for each step
V:SLW:N:0 EOL
Sets the negative voltage slew rate for each step
V:SLW:P:0 EOL
Sets the positive voltage slew rate for each step
V:TLEV:0 EOL
Sets the transient input voltage for each step









List


























Trigger
Voltage


Tran
