Keysight N3300A - Transient Control Keys; Trigger Control Keys; List Control Keys

5 – Front Panel Operation
60
Input Control Keys
Input control keys control the input functions of the electronic load.
Press this key to select another channel. Enter the channel number using the Entry Keys.
(This key performs the same function as ▼ Channel.)
Press this key to access the current menu.
Display Command Function
CURR <value>
Sets the current of input
C:MODE
Sets the current mode to FIX or LIST
C:RANG
Sets the current range
C:SLEW
Sets the current slew rate for both positive and negative transitions
C:SLW:N
Sets the current slew rate for the negative transitions
C:SLW:P
Sets the current slew rate for the positive transitions
C:TLEV
Sets the current transient input level
C:TRIG
Sets the current trigger input level
Press this key to access the resistance menu.
Display Command Function
RES <value>
Sets the resistance of input
R:MODE
Sets the resistance mode to FIX or LIST
R:RANG
Sets the resistance range
R:SLEW
Sets the resistance slew rate for both positive and negative transitions
R:SLW:N
Sets the resistance slew rate for the negative transitions
R:SLW:P
Sets the resistance slew rate for the positive transitions
R:TLEV
Sets the resistance transient input level
R:TRIG
Sets the resistance trigger input level
Press this key to access the voltage menu.
Display Command Function
VOLT <value>
Sets the voltage of input
V:MODE
Sets the voltage mode to FIX or LIST
V:RANG
Sets the voltage range
V:SLEW
Sets the voltage slew rate for both positive and negative transitions
V:SLW:N
Sets the voltage slew rate for the negative transitions
V:SLW:P
Sets the voltage slew rate for the positive transitions
V:TLEV
Sets the voltage transient input level
V:TRIG
Sets the voltage trigger input level
Press this key to access the function menu.
Display Command Function
FUNC <char>
Selects the input regulation mode (CURR, RES, VOLT)
FNC:MODE
Selects what controls the regulation mode (FIX or LIST)
INP:SHOR
Enables or disables the input short (ON, OFF)
Notes
Use and to scroll through the menu commands
Use and to scroll through the command parameters
Current
Res
Voltage
Channel
Shift
Func


 Input
 Input