Keysight N3300A - Entry Keys

Front Panel Operation - 5
61
Transient Control Keys
Transient control keys control the transient functions of the electronic load.
Press this key to access the function menu.
Display Command Function
TRAN <value>
Sets the current of input
T:DCYC
Sets the current mode to FIX or LIST
T:FREQ
Sets the current slew rate for both positive and negative transitions
T:MODE
Sets the current slew rate for the negative transitions
T:TWID
Sets the current slew rate for the positive transitions
Trigger Control Keys
Trigger control keys control the trigger functions of the electronic load.
Press this key to access the function menu.
Display Command Function
INIT:IMMED
Sets the current of input
ABORT
Sets the current mode to FIX or LIST
List Control Keys
List control keys control the list functions of the electronic load.
Press this key to access the function menu.
Display Command Function
LIST:STEP
Sets the method of incrementing steps (ONCE, AUTO)
LST:CNT
Specifies the number of times the list is cycled
DWEL:0 EOL
Specifies the time period of each step
CURR:0 EOL
Specifies the current setting for each step
C:RANG:0 EOL
Specifies the current range for each step
C:SLEW:0 EOL
Sets the current slew rate for each step
C:SLW:N:0 EOL
Sets the negative current slew rate for each step
C:SLW:P:0 EOL
Sets the positive current slew rate for each step
C:TLEV:0 EOL
Sets the transient input current for each step
FUNC:0 EOL
Sets the list regulation mode (CURR, RES, VOLT)
RES:0 EOL
Specifies the resistance setting for each step
R:RANG:0 EOL
Specifies the resistance range for each step
R:SLEW:0 EOL
Sets the resistance slew rate for each step
R:SLW:N:0 EOL
Sets the negative resistance slew rate for each step
R:SLW:P:0 EOL
Sets the positive resistance slew rate for each step
R:TLEV:0 EOL
Sets the transient input resistance for each step
TRAN:0 EOL
Enables/disables the transient level for each step
T:DCYC:0 EOL
Sets the transient duty cycle for each step
T:FREQ:0 EOL
Sets the transient frequency for each step
T:MODE:0 EOL
Sets the mode of the transient generator (CONT, PULSE)
T:TWID:0 EOL
Sets the transient pulse width for each step
VOLT:0 EOL
Specifies the voltage setting for each step
V:RANG:0 EOL
Specifies the voltage range for each step
V:SLEW:0 EOL
Sets the voltage slew rate for each step
V:SLW:N:0 EOL
Sets the negative voltage slew rate for each step
V:SLW:P:0 EOL
Sets the positive voltage slew rate for each step
V:TLEV:0 EOL
Sets the transient input voltage for each step
Tran
Trigger
Control
List