Keysight N3300A - Page 65

5 – Front Panel Operation
64
10.
On the Function keypad, press Input On/Off to turn input on.
Dis annunciator off
11. To make minor changes to an existing value: On the Function keypad, press
Current. On the Entry keypad, press

Input or

Input to scroll from 1.25 to
2.25. Then press Enter.
CURR 2.25
Set the constant resistance mode input
Action
Display
1. On the Function keypad, press  Channel to scroll through the channels until
channel 1 appears on the display.
1
2.
On the Function keypad, press
Input On/Off
to turn input off.
Dis annunciator on
3. On the Function keypad, press Func. On the Entry keypad, press  Input or

Input key until the resistance function is displayed, then press Enter.
FUNC:RES
4.
On the Function keypad, press Res. On the Function keypad, press  key until
resistance is displayed.
RES
5.
On the Entry keypad press 900 Enter.
RES 900
6. On the Function keypad, press Res. On the Function keypad, press  key until
resistance transient is displayed.
R:TLEV
7.
On the Entry keypad press
1000 Enter.
R:TLEV 1000
8.
On the Function keypad, press Input On/Off to turn input on.
Dis annunciator off
9. To make minor changes to an existing value: On the Function keypad, press Res.
On the Entry keypad, press

Input or

Input to scroll from 900 to 950. Then
press Enter.
RES 950
Set the constant voltage mode input
Action
Display
1. On the Function keypad, press  Channel to scroll through the channels until
channel 1 appears on the display.
1
2.
On the Function keypad, press
Input On/Off
to turn input off.
Dis annunciator on
3. On the Function keypad, press Func. On the Entry keypad, press  Input or

Input key until the voltage function is displayed, then press Enter.
FUNC VOLT
4.
On the Function keypad, press Voltage. On the Function keypad, press  key until
voltage is displayed.
VOLT
5.
On the Entry keypad press 6 Enter.
VOLT 6
6. On the Function keypad, press Voltage. On the Function keypad, press  key until
voltage slew is displayed.
V:SLW
7.
On the Entry keypad press
30000 Enter.
V:SLW 30000
8. On the Function keypad, press Voltage. On the Function keypad, press  key until
voltage transient is displayed.
V:TLEV
9.
On the Entry keypad press 4 Enter.
V:TLEV 4
10. On the Function keypad, press
Input On/Off
to turn input on.
Dis annunciator off
11. To make minor changes to an existing value: On the Function keypad, press
Voltage. On the Entry keypad, press

Input or

Input to scroll from 6.000 to
7.000. Then press Enter.
VOLT 7.000