B - Performance Test and Calibration
82
6. Set power source voltage and current values as listed in following table.
Power Source Voltage Setting
Power Source Current Setting
7. Wait 15 seconds. Calculate and record resistance range 2 high resistance point
Resistance Range 3 Programming Accuracy
1. Press [ RES ]. Scroll until display reads RES:RANG. For models N3302A, N3304A, N3305A, and N3306A press
[ 1 ] [ 0 ] [ 0 ] then [ Enter ]. For models N3303A and N3307A press [ 5 ] [ 0 ] [ 0 ] then [ Enter ].
2. Checking resistance range 3, low resistance point. Press [ RES ] [select resistance from following table ] [ Enter ].
3. Set power source voltage and current values as listed in following table.
Power Source Voltage Setting
Power Source Current Setting
4. Wait 7 seconds. Calculate and record resistance range 3 low resistance point.
5. Checking resistance range 3, high resistance point. Press [ RES ] [select resistance from following table ] [ Enter ].
6. Set power source voltage and current values as listed in following table.
Power Source Voltage Setting
Power Source Current Setting
7. Wait 7 seconds. Calculate and record resistance range 3 high resistance point.
Resistance Range 4 Programming Accuracy
1. Press [ RES ]. Scroll until display reads RES:RANG. For models N3302A, N3304A, N3305A, and N3306A press
[ 1 ] [ 0 ] [ 0 ] [ 0 ] then [ Enter ]. For model N3303A press [ 5 ] [ 0 ] [ 0 ] [ 0 ] then [ Enter ]. For model N3307A press
[ 2 ] [ 0 ] [ 0 ] [ 0 ] then [ Enter ].
2. Checking resistance range 4 low resistance point. Press [ RES ] [select resistance from following table ] [ Enter ].
3. Set power source voltage and current values as listed in following table.
Power Source Voltage Setting
Power Source Current Setting
4. Wait 3 seconds. Calculate and record resistance range 3 low resistance point.
5. Checking resistance range 4, high resistance point. Press [ RES ] [select resistance from following table ] [ Enter ].
To Next Page
Loading...
