Keysight N5186A - Page 28

28 N5186A MXG and X-Series SA Measurement Guide
Basic Measurements
Making Measurements
Using the equivalent SCPI commands
On the MXG:
SYSTem:PRESet
RF1:FREQuency:CW 6GHZ
RF1:POWer:AMPLitude 0dBm
SIGNal:MODE AMODulation
SIGNal1:AMODulation:TYPE PM
SIGNal1:PM:SHAPe SINE
SIGNal1:PM:FREQuency 10KHZ
SIGNal1:PM 1
SIGNal1 ON
RF1:OUTPut:STATe ON
For multi-channel instruments, set RF Out (all) to On.
RFALl:OUTPut ON
On the Signal Analyzer:
INSTrument:CONFigure:ADEMOD:PM
SYSTem:PRESet
DISPlay:VIEW:ADVanced:SELect "QUAD"
FREQuency:CENTer 6GHZ