To Next PageTo Next Page
Need help?Do you have a question about the Keysight N8976B and is the answer not in the manual?
General| Frequency Range | 10 MHz to 26.5 GHz |
|---|---|
| Input Impedance | 50 Ω |
| Interfaces | LAN, USB, GPIB |
| Resolution Bandwidth (RBW) | 1 Hz to 3 MHz in 1-3-10 sequence |
| Detectors | Peak, Average |
| Noise Figure Range | 0 dB to 30 dB |
| Dimensions | 177 mm (H) x 426 mm (W) x 470 mm (D) |
Provides procedures for isolating hardware problems by verifying RF section assembly functionality.
Describes the RF section for the N8976B model, including its four front-end signal paths.
Describes the functionality and purpose of the A15 Front End Controller board.
Provides troubleshooting procedures for the A15 Front End Control Assembly.
Describes the L.O. Synthesizer assembly, its inputs, outputs, and tuning range.
Provides troubleshooting procedures for the L.O. Synthesizer assembly.
Describes the A16 Reference Assembly, its purpose, and signal sources.
Provides troubleshooting procedures for the A16 Reference Assembly, including diagnostic LEDs.
Describes the A4 Processor assembly, its components, and rear panel connectivity.
Details troubleshooting steps for the A4 Processor assembly, including boot-up issues and BIOS settings.
Describes the A5 Disk Drive, its partitioning, and the Instrument Image Recovery System.
Provides troubleshooting steps for software-related issues concerning the A5 Disk Drive.
Outlines basic troubleshooting steps for the A6 Power Supply with the cover on.
Provides troubleshooting steps for the A7 Midplane Assembly, including power supply verification.
Provides removal and replacement steps for the RF Front End Assembly for specific models.
Details the removal and replacement procedures for the RF Front End Assembly for the N8976B model.
Outlines the removal and replacement steps for the Front End Control Assembly.
Provides procedures for removing and replacing the L.O. Synthesizer assembly.
Outlines the removal and replacement procedures for the Reference Assembly.
Provides steps for removing and replacing the Power Supply assembly.
Details the removal and replacement procedures for the CPU assembly.
Outlines the removal and replacement steps for the SSD or memory card.
Details the removal and replacement steps for the Analog/Digital IF assemblies.
Provides removal and replacement steps for the Midplane Assembly.
Details the removal and replacement procedures for the Motherboard Assembly.
Details the removal and replacement steps for the Front Frame Assembly.
Lists adjustments and performance verification tests required after assembly replacement.
Describes tests to ensure analyzer operation and conformance to published specifications.
