398 Keysight N9010B EXA Signal Analyzer Service Guide
Replaceable Parts
Replaceable Parts
W41 Cable Assembly, A2J601 to A3J19 (Flexible Coax) 8120-8868
W42 Cable Assembly, A16J706 to A3J14 (Flexible Coax) 8121-1401
W43 Reserved
W44 Cable Assembly, A25J2 to A26J504 (Flex cable) 8121-1854
W45 Cable Assembly, SW4 Port 1 to A11J3 (semi-rigid)
Option 532, 544 with Option MPB
N9010-20009
W46 Cable Assembly, SW4 Port 2 to A13J9 (semi-rigid)
Option 532, 544 with Option MPB
N9020-20130
W47 Cable Assembly, SW4 Port 3 to A12 Output (semi-rigid)
Option 532, 544 with Option MPB
N9020-20129
W48 Cable Assembly, SW4 Port 4 to A12 Input (semi-rigid)
Option 532, 544 with Option MPB
N9020-20128
W49 Reserved
W50 Cable Assembly, A16J726 to A3J17 (Flexible Coax) 8121-1401
a. Included, but not required for use on N9010B.
b. Does not include nameplate. See A1MP3 through A1MP6.
c. Disk drive removable through rear panel.
d. The E4410-60121 is the preferred replacement for the N9020-60255 Low Band Switch that may be
installed in some N9010Bs with Option 503.
e. N9020-60172 is the preferred replacement for N9020-60222.
f. Front panel protective cover p/n N9020-40004 is optimized only for use on analyzers with the porta-
ble configuration, Opt PRC. Although the cover will fit on analyzers with the benchtop configuration,
its use on benchtop configurations is not recommended.
Table 14-1 All Replaceable Parts
Reference
Designator
Description Part Number
To Next Page
Loading...
