441
Keysight X-Series Signal Analyzers
N9010B EXA Signal Analyzer
Service Guide
15 Assembly Replacement Procedures
What You Will Find in This Chapter
Procedures in this chapter enable you to locate, remove, and replace the
following major assemblies in your instrument.
Refer to Chapter 14, “Replaceable Parts.” for part numbers, assembly
descriptions, and ordering information.
“Instrument Outer Case” on page 445
“Top Brace” on page 450
“RF Area (Option 503, 507, 513, 526)” on page 451
“RF Area (Option 532, 544)” on page 478
“RF Front End Assembly (Option 503, 507, 513, 526)” on page 493
“RF Front End Assembly (Options 532, 544)” on page 495
“Front End Control Assembly” on page 497
“L.O. Synthesizer Assembly” on page 500
“Rear Panel” on page 501
“Reference Assembly” on page 502
“Power Supply Assembly” on page 505
“CPU Assembly” on page 507
“A5 Solid State Drive” on page 509
“Analog I.F. (AIF)/Digital I.F. (DIF) Assembly” on page 514
“Midplane Assembly” on page 519
“Motherboard Assembly” on page 522
“Fan Assembly” on page 527
“Input Connector Assembly” on page 530
“Front Frame Assembly” on page 532
“Display Assembly” on page 541
To Next Page
Loading...
