486
Assembly Replacement Procedures
Rear Panel
Rear Panel
Removal
1. Remove the instrument outer case. Refer to the Instrument Outer
Caseremoval procedure.
2. Refer to Figure 14-39. Using the T-10 driver, remove the twenty screws
(2) attaching the rear panel (1) to the chassis and to the reference
bracket. The rear panel can now be removed.
3. Refer to “Reference Assembly” on page 487. Remove W23 cable from the
A16 Reference Assembly (1) at A16J704.
NOTE If the rear panel is being replaced with a new rear panel, remove W23 at the
rear panel using a 9/16-inch nut driver. Instruments with Option CR3 or CRP
will have an additional cable W39 that is attached to the rear panel.
Figure 14-39 Rear Panel Removal
Replacement
1. Reattach W23 cable to A16J704 or to the rear panel depending on how
you removed it.
2. Refer to Figure 14-39. Place the rear panel (1) into position in the chassis.
Replace the twenty screws (2) to attach the rear panel to the chassis.
Torque to 9 inch-pounds.
3. Replace the instrument outer case. Refer to the Instrument Outer
Casereplacement procedure.
To Next Page
Loading...
