Keysight N9020A - 14 Assembly Replacement Procedures; What You will Find in this Chapter

435
Keysight X-Series Signal Analyzers
N9020A MXA Signal Analyzer
Service Guide
14 Assembly Replacement Procedures
What You Will Find in This Chapter
Procedures in this chapter enable you to locate, remove, and replace the
following major assemblies in your instrument.
Refer to Chapter 13, “Replaceable Parts.” for part numbers, assembly
descriptions, and ordering information.
“Instrument Outer Case” on page 440
“Top Brace and Reference Bracket” on page 445
“RF Area” on page 447
“RF Front End Assembly” on page 479
“Front End Control Assembly” on page 481
“L.O. Synthesizer Assembly” on page 484
“Rear Panel” on page 486
“Reference Assembly” on page 487
“Power Supply Assembly” on page 492
“CPU Assembly” on page 495
“Disk Drive” on page 498
“Analog I.F. (AIF)/Digital I.F. (DIF) Assembly” on page 511
“Wide Band Analog IF and Digital IF Assemblies” on page 516
“Midplane Assembly” on page 518
“Motherboard Assembly” on page 521
“Fan Assembly” on page 526
“Input Connector Assembly” on page 529
“Front Frame Assembly” on page 531
“Display Assembly - LCD” on page 537
“Display Assembly - LED” on page 546
“Inverter Board” on page 550