531
Assembly Replacement Procedures
Front Frame Assembly
Front Frame Assembly
Removal
NOTE Make sure any connectors on the front panel are removed.
1. Remove the instrument outer case. Refer to the Instrument Outer
Caseremoval procedure.
NOTE If the analyzer has Option PRC, Portable Configuration, and you want to
remove the bail handle and bumpers from the front frame, refer to the “Bail
Handle Removal (Option PRC)” section on page 533.
2. Refer to Figure 14-76. Using the T-10 driver, remove the eight screws (1),
four on each side, to detach the Front Frame Assembly from the chassis.
Figure 14-76 Front Frame Assembly Removal
To Next Page
Loading...
