546
Assembly Replacement Procedures
Front Frame Assembly
Display Assembly - LED
Removal
1. Refer to Figure 14-85. Remove the front panel shield by removing the four
screws (28).
2. Refer to Figure 14-86. Disconnect the flex circuit A1W1 (1) and A1W3 (2)
from the front panel interface board (4).
Figure 14-86 Display Removal - LED
3. Remove the screw (3) securing the display bracket to the Front Frame
Assembly. The display can now be removed from the Front Frame
Assembly.
CAUTION Once the display assembly has been removed from the Front Frame
Assembly, the glass filter is no longer secured. DO NOT tip the assembly in
such a manner that would cause it to fall out of place, as this may cause
injury and/or damage to the glass.
4. Refer to Figure 14-87. To separate the LCD (2) from the display bracket
(1), remove the four screws (3). When reassembling, torque the four
screws to 5 inch-pounds.
To Next Page
Loading...
