547
Assembly Replacement Procedures
Front Frame Assembly
5. To separate the DC to DC Converter (4) from the display bracket (1),
remove the two screws (5). When reassembling, torque the two screws
to 9 inch-pounds.
Figure 14-87 LED and Display Bracket Separation
Replacement
1. Refer to Figure 14-86. Place the display bracket into position in the Front
Frame Assembly. Reconnect the flex circuit A1W1 (1) and A1W3 (2) to
the front panel interface board (4).
2. Replace the screw(3) that secures the display bracket to the Front Frame
Assembly. Torque to 9 inch-pounds.
3. Replace the front panel shield.
To Next Page
Loading...
