3 Short-Range Comms & IoT Mode
3.12 Monitor Spectrum Measurement
Each parameter, upon being set to Auto, selects and sets the appropriate auto-
coupled value based on that parameter’s coupling rules. The Dependency Resolver
orchestrates the couplings for parameters that depend on one or more other
parameters. The coupling and dependency rules for each parameter are defined in
the section describing that parameter.
Executing Auto Coupledoes not affect markers, marker functions, trace or display
attributes, or any other instrument setting other than those specifically mentioned
above.
Measurement-Specific Details
TOI (SA Mode only)
Parameters affected by Auto Couple are:
–
Center Frequency Step
–
Resolution Bandwidth
–
Span/RBW Ratio
–
Sweep Time
–
Video BANDwidth VBW/RBW ratio
–
Upper and Lower Tone (set to Sense)
–
Zero span measurement Resolution Bandwidth
–
Zero span measurement Dwell Time
Harmonics (SA Mode only)
Parameters affected by Auto Couple are:
–
Resolution Bandwidth
–
Fundamental Frequency
–
Dwell Time
–
Range Table Resolution Bandwidths
–
Range Table Dwell Times
1710 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
