7 Save/Recall/Print
7.2 Recall
N7610C Setup Files:
Extension:scp
Signal Studio N7610C (IoT) configuration file, when PHY Specification is 802.15.4
HRP UWB.
Remote Command
:MMEMory:LOAD:HUWB:SETup <string>
Example
:MMEM:LOAD:HUWB:SET "mySetup.scp"
Dependencies Only appears in Short Range Comms Mode, in the HRP UWB measurement
Annotation After recall is complete, an advisory is displayed in the message bar confirming that the filter’s coeffi-
cients were loaded
Status Bits/OPC
dependencies
Sequential – aborts the current measurement
2254 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
