Keysight N9020B - Page 871

To Next Page

To Previous Page

3 Short-Range Comms & IoT Mode

3.7 ACP Measurement

** RF BW = BWchannel,CA

which is defined in each 3GPP standard, regardless of

“Measure Carrier” for the uppermost and the lowermost carriers being Enabled or

Disabled. When the Number of Component Carrier = 1, RF BW = BW

channel

= 2 x

offset,RAT

** sub-block (bandwidth) = BW

channel,block

which is defined in each 3GPP standard,

regardless of “Measure Carrier” for the uppermost and the lowermost carriers being

Enabled or Disabled. When the Number of Component Carrier within each sub-

block = 1, sub-block (bandwidth) = BW

channel

= 2 x F

offset,RAT

See "Diagrams for Offset Freq Define" on page 872.

Modes other than MSR, LTEAFDD, LTEATDD, 5G NR

Remote

Command

[:SENSe]:ACPower:OFFSet[1]|2[:OUTer]:TYPE CTOCenter | CTOEdge | ETOCenter |

ETOEdge

[:SENSe]:ACPower:OFFSet[1]|2[:OUTer]:TYPE?

Subopcode: 1 = BTS/Downlink (Default), 2 = MS/Uplink

Example

:ACP:OFFS:TYPE ETOC

:ACP:OFFS:TYPE?

Notes Some Modes do not support Offset subopcode 2. In those cases, commands with subopcode 2 are

accepted without error but ignored

Preset

CTOCenter

State Saved Saved in instrument state

Range

CTOCenter|CTOEdge|ETOCenter|ETOEdge

Mode: MSR, LTEAFDD, LTEATDD