144 Keysight N9927-90001 User’s Guide
SA (Spectrum Analyzer) Mode
In this Chapter
“Frequency Range” on page 146
“Radio Standard” on page 148
“Channel Selection” on page 149
“Reverse Swap” on page 151
“Scale and Units” on page 151
“External Gain” on page 152
“Attenuation Control” on page 152
“Preamplifier Control (Opt 235)” on page 153
“Check for Compressed Measurements” on page 153
“Field Strength Measurements” on page 154
“Using the Antenna/Cable Editor” on page 156
“Source Tracking Offset and Offset Reversal” on page 158
“Tune & Listen (AM/FM)” on page 159
“Independent Source/Tracking Generator ” on page 161
“Resolution Bandwidth (Res BW)” on page 163
“Video Bandwidth (Video BW)” on page 164
“Sweep Type” on page 164
“IF Output” on page 165
“Sweep Acquisition” on page 166
“Very Long Sweep Times” on page 167
“Zero Span Measurements” on page 167
“Triggering” on page 169
“FFT Gating (Opt 238)” on page 172
“Single / Continuous / Restart” on page 174
“Points ” on page 174
“Trace Display States (SA Mode)” on page 175
“Average Type” on page 176
“Average Count” on page 176
“Alignments” on page 177
To Next Page
Loading...
