472 Keysight N9927-90001 User’s Guide
System Settings
Run/Hold
“Variable Voltage Source (Opt. 309)” on page 494
“Security Level” on page 495
“Date and Time, Format, and Time Zone Settings” on page 495
“LAN Settings” on page 497
“Power ON” on page 498
“FieldFox Package Installer (N995xA, N996xA, and applies to:
N991xA/2xA/3xA units with serial number prefixes ≥5607)” on
page 499
“Date and Time, Format, and Time Zone Settings” on page 495
“Service Diagnostics” on page 501
See Also:
“Install the Lithium-Ion Battery” on page 26
“FieldFox High Temperature Protection” on page 28
Run/Hold
The Run/Hold key determines whether the FieldFox sweeps continuously or
does NOT sweep, but holds the display results of the last sweep that was
performed.
Use Hold to conserve battery power or to allow you to save or analyze the
results of a specific measurement sweep.
The current sweep mode is shown on the screen as:
— Continuous
—Hold
— is displayed while a single sweep occurs.
How to perform a single sweep while in Hold
—Press Sweep 3.
— Then choose one of the following:
— Single
Automatically sets Continuous OFF (Hold) and causes
FieldFox to make ONE measurement sweep, then hold for the next
Single key press.
— SA Mode ONLY – With Continuous OFF
each successive Run/Hold
press also causes a single sweep.
To Next Page
Loading...
