307
Keysight Handheld Analyzers
N99xxA User’s Guide
17 Frequency Offset Using Power Sensor (FOPS) – Option
208
FOPS is accessed through (and requires) Option 302 USB Power Meter Mode.
With both options installed, you can send a signal with the FieldFox internal
source at one frequency, and measure this signal with a Keysight U-Series USB
Power Sensor at another frequency.
Figure 17-1 Display for FOPS
In this Chapter
“How to select Power Meter (USB Sensor)” on
page 311
“Measurement Selection” on page 311
“Sweep Type and Frequency” on page 312
“Power Sensor Settling” on page 314
“Sweep Settings” on page 314
To Next Page
Loading...
