Keysight N9927-90001 User’s Guide 397
Noise Figure Mode (Option 356 – CPU2 Only)
In this Chapter:
See Also
“Using Noise Figure” on page 398
“How to Define a Noise Figure Measurement” on page 402
— “Example: Typical Noise Figure Measurement Procedure”
on page 402
— “Overview of Softkey Menus” on page 403
— “How to Use DUT Measurement Setups” on page 410
— “Single / Continuous / Restart” on page 422
— “Points ” on page 422
— “Alignments” on page 423
— “Calculating Noise Figure Measurement Uncertainty” on
page 424
— “Using ENR Tables” on page 429
— “About ENR (*.enr), Preamplifier (*.amp), and DUT (*.dut)
Files” on page 430
— “Using Markers (Noise Figure)” on page 432
“Calibration Wizard” on page 433
“How to use Auto-Integration” on page 436
“Other Features Available” on page 442
“Troubleshooting” on page 443
“All about Markers” on page 446
“All about Limit Lines” on page 461
“All about Trace Math” on page 466
“All about Scale Settings” on page 468
Chapter 24, “Data Analysis Features.”
Chapter 27, “File Management.”
To Next Page
Loading...
