4
A.08.18 Firmware Release (CPU1) Updates (N991xA/2xA/3xA with
serial number prefixes <5607)
For customers upgrading FieldFox firmware, the following is a list of changes from the previous release:
Other updates:
— N755xA ECal support
— CAT/TDR default changed to "Cable"
—NA/CAT OSL ≥4001 points calibrations
— Normalization cal behavior
— Internet time update behavior
A.10.30 Firmware Release (CPU2) Updates (Also, applies to:
N991xA/2xA/3xA units with serial number prefixes
≥5607
1
)
For customers upgrading FieldFox firmware, the following is a list of changes from the previous release:
Added Noise Figure Mode:
Chapter 23, “Noise Figure Mode (Option 356 – CPU2 Only),” on page 395
1. Country codes have been omitted from serial number prefixes.
To Next Page
Loading...
