Keysight PNA-X Series Configuration Guide

Page 6
Find us at www.keysight.com
PNA Family Network Analyzer Configurations (Continued)
Hardware options
Description For PNA-X
Series
For PNA
Series
For PNA-L
Series
Additional Information
Add IF inputs N524xB-020 N522xB-020 N/A Used for antenna measurements and mm-wave extenders
Add pulse modulator to first source N524xB-021 N522xB-021 N/A
Add pulse modulator to second source N524xB-022 N522xB-022 N/A Requires one of Option 222, 224, 4xx
Add low-noise receiver N524xB-029 N/A N/A S93029A application software is needed to control
the noise receiver for noise figure and noise power
measurements. For N5241/42/49B, requires one of
options 21x, 22x, 41x, or 42x. For N5244/45/47B,
requires one of options 22x or 42x. On N5247B, noise
receiver works up to 50 GHz only.
PNA-X Series PNA Series PNA-L Series Test Port Connector
N5249B 900 Hz/10 MHz to 8.5 GHz N5239B 300 kHz to 8.5 GHz 3.5 mm (male)
N5241B 900 Hz/10 MHz to 13.5 GHz N5221B 900 Hz/10 MHz to 13.5 GHz N5231B 300 kHz to 13.5 GHz 3.5 mm (male)
N5242B 900 Hz/10 MHz to 26.5 GHz N5222B 900 Hz/10 MHz to 26.5 GHz N5232B 300 kHz to 20 GHz 3.5 mm (male)
N5244B 900 Hz/10 MHz to 43.5 GHz N5224B 900 Hz/10 MHz to 43.5 GHz N5234B 10 MHz to 43.5 GHz 2.4 mm (male)
N5245B 900 Hz/10 MHz to 50 GHz N5225B 900 Hz/10 MHz to 50 GHz N5235B 10 MHz to 50 GHz 2.4 mm (male)
N5247B 900 Hz/10 MHz to 67 GHz N5227B 900 Hz/10 MHz to 67 GHz 1.85 mm (male)

Keysight PNA-X Series Specifications

General

Output Power	+13 dBm (typical)
Number of Ports	2 or 4
Dimensions	426 mm (W) x 470 mm (D)
Power Requirements	100 to 240 VAC, 50/60 Hz
Frequency Range	10 MHz to 26.5 GHz (varies by model)