8 U9361C/F/G/M RCal Measurement Guide
Getting Started
LED Indicators on RCal Module
LED Indicators on RCal Module
At startup, ensure the RCal 10 MHz Reference Input is connected to the
10 MHz Output of the signal analyzer. Connect the RCal USB-C port to a high
power USB port on the signal analyzer’s front or rear panel (blue USB 3.0 or
USB port with a lightening bolt next to it).
After startup, the LEDs indicate the following status messages:
Status LED RF Out LED 10 MHz Ref LED
Off = No USB Connection Off = No RF Output Off: Internal Reference Used
Green = On, Ready, Stable
Green Blink = Busy
Green = RF Out On Green = External Ref locked successfully
Amber Blink = Temperature
Unstable (during warm-up period)
- -
Red = USB Power Failure
Red Blink = Processor Error
Red Blink = USB Power Failure Red Blink = External Ref unlocked
Blue Blink = Self Identification - -
To Next Page
Loading...