81
Keysight Vector Signal Generator
U9361C/F/G/M RCal Receiver Calibrator
Measurement Guide
3 Programming with MATLAB
This section explains how to setup and initialize the Frequency Extender with
the Vector Signal Generator.
SCPI commands can be used to help simplify and speed up the RCal
configuration and calibration process. The software for RCal calibrations is
stored and executed on the analyzer itself, so commands must be made
through a USB, VISA, or GPIB connection to the signal analyzer directly.
Additionally, some of the following programming examples require a
connection to the signal generator in the test setup.
To Next Page
Loading...