48 U9361C/F/G/M RCal Measurement Guide
Making Measurements
Using RCal Data Generated on X-Apps but Used with the 89600 VSA Software
Using RCal Data Generated on X-Apps but Used with the 89600
VSA Software
Compatible Signal Generators:
— N5166B (CXG)
— N517xB (all EXG)
— N518xB (all MXG)
— N519xA (all UXG)
Before beginning the following demo, complete “Using Complex Cal to
Improve EVM in a 128 QAM Signal” on page 42 Demo #3 for RCal calibration
setup for the mW path.
On the Signal Analyzer:
1. Select Mode/Measure > Launch VSA to start the VSA application.
2. Set Center Frequency to 5 GHz and Span to 20 MHz. Select the
Auto-range icon to bring the signal up on the display.
3. Select Window > Trace Layout > Grid 2x2.
To Next Page
Loading...