12 U9361C/F/G/M RCal Measurement Guide
Getting Started
RCal Software - Configuration
Shown below are all parameters (columns) for an RCal calibration state (row):
RCal Configuration Table – Parameters
The following table details the parameters for each column in every calibration
row.
Not all columns fit on the display screen. Use a finger or mouse to grab
the scroll bar (just below the bottom of the active row) and scroll to the
left, or right to see all columns.
Column Title Description Additional Information
Calibrate
(checkbox)
Rows that are selected will be included when
Calibrate Checked Rows is used to start a
calibration.
Apply
(checkbox)
Rows that are successfully calibrated will be
applied to measurements when selected.
Name
User defined row name.
Last Calibrated
(Read only) Date and time that last calibration
was successfully executed.
Applied
(Read only)
“Yes” if successfully applied, “---“ if not yet
calibrated, and “No” if not applied.
Ext Mixer (Read only)
Applies only if Input = Ext Mixer
To Next Page
Loading...