U9361C/F/G/M RCal Measurement Guide 61
Making Measurements
Using RCal Directly from the 89600 VSA
9. Select the System Calibrator dropdown and select SystemCalibration1.
10. Select the System Calibration tab and set parameters as applicable. For
this example, we will use the default values for this example. Select
Calibrate.
Within this dialog box, you can define parameters such as:
— Start and Stop Frequency
— Number of Points
— Magnitude Flatness Threshold
— Phase Linearity Threshold
— Calibration File Name, if you want to reuse the coefficients from this
calibration at a later time
— Setup File Name and more
To Next Page
Loading...