24
K5 FEATURES & FUNCTIONS GUIDE
STEERING WHEEL CONTROLS
STEERING WHEEL
CONTROLS
*IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
Smart Cruise Control
(SCC) Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to inside
front cover information.
www.youtube.com/KiaFeatureVideos
QR CODE
SCC is a supplemental system
and is not a substitute for safe
driving. It is the responsibility of
the driver to always check the
speed and distance to the vehicle
ahead.
For illustrative purposes only.
Your actual display, buttons
and/or features may vary.
See section 5 in the Owner’s
Manual for more information.
Smart Cruise Control (SCC)
†6a,21
Smart Cruise Control (SCC) is designed to maintain a predetermined distance from vehicles detected ahead by automatically
adjusting the driving speed as needed. When traffic is detected, the vehicle will slow down to maintain a set distance behind
traffic without depressing the accelerator or brake pedal.
With SCC on and activated and the vehicle distance set, when the system detects a vehicle slowing or stopping, the system can
bring the vehicle to a complete stop. When the vehicle ahead starts to move forward, SCC re-engages. If the vehicle ahead stops for
more than 3 seconds, the accelerator pedal or the RES+ button must be pressed to start moving the vehicle.
To set/adjust the SCC speed:
• Accelerate/decelerate to the desired speed
• Press the Driving Assist button
A
to turn system ON and set speed. The CRUISE
indicator will illuminate on the instrument cluster and the set speed will automatically
activate at the vehicle’s current speed
• Press the button
B
inward to pause/resume the cruise control
• Press the
+
/
-
button
B
up/down to increase/decrease the set speed. The SET indicator
light, set speed and vehicle distance will illuminate on the instrument cluster’s LCD
screen
To set the vehicle distance: Press the Vehicle Distance button
C
on the steering
wheel. Scroll through the selections and the vehicle-to-vehicle distance image changes
and displays on the Instrument Cluster LCD.
To pause/resume SCC operation: Press the button
B
to pause or resume Cruise Control.
To turn SCC system OFF: Press the Driving Assist button
A
. The CRUISE indicator on the
instrument cluster will turn OFF.
To adjust the sensitivity of SCC: Press the mode button
D
on the Steering Wheel. With the OK
button
E
, select Drive Assistance, then SCC Response. Then select Fast, Normal or Slow.
To change the cruise control mode from SCC to standard cruise control, press and hold
button
C
. Repeat to switch back to SCC mode (the SCC system must not be activated
to change modes).
(Type B Steering Wheel buttons)
A
B
C
D
E
To Next Page
Loading...
Need help?
General
