TM0024 Page 16 of 33 Issue 2.01
While the zone is in the normal status, operation of the Enter key will alter the
“Norm” status of the selected zone to “ISOLATED”, this will be displayed for a short
time period. Upon the selection of isolation the common isolate and the relevant
zonal led will illuminate. After the short time period for the display of the “ISOLATED”
text the display will revert to “Isol” which will pulse until the zone is returned to its
“Norm” status as shown in figure 3.2.
Access level 2 Isolate
Zone 011 Store Room Area Bld.6 Norm
Zone 012 Goods Receive Area Bld 6 Isol
Zone 013 ISOLATED
Zone 014 Product Inspection Area Norm
Zone 015 General Administration Norm
Zone 016 Main Reception Area Norm
Select option using ↑ &
↵
Figure 3.2
To return the isolated zone to its normal operating status, “Norm”, operate the Enter
key on the required zone which is Isolated and a confirmation message of “DE-
ISOLATED” will appear. Repeated operation of the Cancel key will return the display
through the menu selections and continued operation will return the repeater to
access level 1 where the display will show a devices isolated message as shown in
figure 3.3 if any zones are isolated.
DEVICES
Sat 30 Mar 96
ISOLATED
Figure 3.3
To Next Page
Loading...