TM0024 Page 21 of 33 Issue 2.01
4.5 PLANT
Upon the selection of this menu option and if the plant indications have not been
setup within the “Panel Setup” menu selection a message will appear stating “Plants
are not enabled”. When the plants have been setup the isolate and de-isolate
procedure for the plant indications is similar in format to that of Zones as section 4.1,
however the only difference is that the zone reference is replaced with “Plant”. When
a Plant area has been isolated the “Common” and “Device Isolate” LEDS will be lit
and when the display reverts to access level 1 the display will be as per figure 3.3
Operation of the Cancel key will return the display through the menu selections and
continued operation will return the panel to access level 1 where the display will show
a devices isolated message as shown in figure 3.3.
To Next Page
Loading...