TM0024 Page 25 of 33 Issue 2.01
Single Loop
Selection requests a loop number to be entered and once entered the display will
show the total of devices attached to the selected loop. Upon the operation of any
key the display will show the information on the devices attached to the selected loop
as shown in figure 4.6.
Access level 2 List loop devices
D008.1 Loop 01 Zone 011 Status ISOL
I/O Unit Emer. Door Closer
D010.1 Loop 01 Zone 011
Ionisation UNASSIGNED
D011.1 Loop 01 Zone 011
Optical Stores Office Area
↑ to scroll, →
to quit
Figure 4.6
Operation of the arrow keys will scroll the devices on the display. When viewing is
complete operation of the Cancel key will quit the display to the menu and continued
operation will return the panel to access level 1.
Device Range
Selection requests a loop number to be entered and once entered the display will
show the total of devices attached to the selected loop as shown in figure 4.7.
Access level 2 List loop devices
Loop 01 107 Devices
Start 1_ _ End _ _ _
Enter required start/end address &
↵
figure 4.7
Upon the operation of any key the display will then request a Start and End device
number. When entered the display will show the information for the selected device
range as shown in figure 4.7.
Operation of the arrow keys will scroll the devices on the display. When viewing is
complete operation of the Cancel key will quit the display to the menu and continued
operation will return the panel to access level 1.
To Next Page
Loading...