iv P/N 3102351-EN • REV 005 • ISS 28DEC18
Important information
Limitation of liability
This product has been designed to meet the requirements of NFPA 72 National Fire Alarm and
Signaling Code, NFPA 720 Standard for the Installation of Carbon Monoxide (CO) Detection
and Warning Equipment, UL 864 Standard for Control Units and Accessories for Fire Alarm
Systems, and ULC-S527 Standard for Control Units for Fire Alarm Systems, UL 2017 General
Purpose Signaling Devices and systems. Installation in accordance with this manual,
applicable codes, and the instructions of the authority having jurisdiction (AHJ) is mandatory.
United Technologies Corporation shall not under any circumstances be liable for any incidental
or consequential damages arising from loss of property or other damages or losses owing to
the failure of United Technologies Corporation products beyond the cost of repair or
replacement of any defective products. United Technologies Corporation reserves the right to
make product improvements and change product specifications at any time.
While every precaution has been taken during the preparation of this manual to ensure the
accuracy of its contents, United Technologies Corporation assumes no responsibility for errors
or omissions.
FCC compliance statement
This equipment can generate and radiate radio frequency energy. If the equipment is not
installed in accordance with this manual, it may cause interference to radio communications.
This equipment has been tested and found to comply with the limits for Class A computing
devices pursuant to Subpart B of Part 15 of the FCC Rules. These rules are designed to
provide reasonable protection against such interference when this equipment is operated in a
commercial environment. Operation of this equipment is likely to cause interference, in which
case the user, at their own expense, will be required to take whatever measures may be
required to correct the interference.
SA-DACT FCC information
Cautions
• To ensure proper operation, this dialer must be installed according to the enclosed
installation instructions. To verify that the dialer is operating properly and can successfully
report an alarm, it must be tested immediately after installation, and periodically thereafter,
according to the enclosed test instructions.
• In order for the dialer to be able to seize the phone line to report an alarm or other event
when other customer equipment (telephone, answering system, computer modem, etc.)
connected to the same line is in use, the dialer must be connected to a properly installed
RJ-31X jack. The RJ-31X jack must be connected in series with, and ahead of, all other
To Next Page
Loading...
