P/N 3102351-EN • REV 005 • ISS 28DEC18 i
Content
Important information iv
Minimum system requirements vii
To get started vii
Chapter 1 Installation and wiring 1
Panel backbox installation 2
Panel electronics installation 4
Panel backbox wire routing 5
AC power wiring 6
Panel transformer wiring 7
Battery wiring (TB8) 8
Notification appliance circuit wiring (TB2) 10
Addressable device loop wiring 12
Alarm, trouble, and supervisory relay wiring (TB3) 16
Remote annunciator wiring (TB4) 17
Auxiliary/smoke power output wiring 19
SA-DACT wiring 21
SA-232 wiring 23
SA-CLA wiring 26
SA-ETH wiring 27
CTM module wiring 28
RPM module wiring 30
Chapter 2 Front panel programming 33
UL/ULC programming requirements 35
Getting started 37
Device type descriptions 49
Displaying the Program menu 59
Setting the time and date 59
Setting daylight saving time 60
Changing the passwords 61
Restoring the factory default settings 61
Setting up the programmable keys 62
Clearing the event history log 65
Updating the firmware 66
Restarting the panel 67
Enabling RS-232 communication 67
Auto programming the panel 68
Performing incremental programming 74
Adding and removing devices from programmed systems 77
Advanced programming 81
To Next Page
Loading...
